Proslat 8 ft. PROCORE PVC Top Trim

This is the top trim for Proslat PROCORE PVC slatwall. Each piece is 8 ft long and caps the top edge of the highest panel in your run, so you see a clean horizontal line instead of the open back of the slat profile. It is sold here in 3 pack, 4 pack and 5 pack sizes.

Where this trim goes

Top trim runs horizontally along the very top of the installation, above the last panel you hang. It covers the exposed edge at the top of the wall and gives the run a finished border where it meets bare drywall.

There are four trim pieces in the PROCORE line and they are not interchangeable:

• Starter trim goes at the bottom. It is the first piece on the wall and sets the level for every panel above it.
• H-trim covers a vertical seam where two panel sections meet side by side in the same run.
• Top trim — this piece — caps the top edge of the installation.
• Side trim finishes the open left and right ends of the wall.

How many do I need?

Every piece is 8 ft. For top trim, the measurement that matters is the full width of the installation — the horizontal distance from the left end of the panel run to the right end, in linear feet. Do not measure the height, and do not count panels.

Take that width, divide by 8, and round up to the next whole number. A 16 ft wall needs 2 pieces. A 20 ft wall needs 3, because 20 divided by 8 is 2.5 and you round up. Then pick the pack that covers the count.

Common questions

Can I cut it to length?

Yes. This is PVC and it cuts cleanly with a fine-tooth blade. A miter saw or a hand saw with a fine-tooth blade both work. Cut slowly so the edge does not chip.

Does the finish have to match my panels?

Visually, yes. This is PROCORE PVC trim and it is made to match PROCORE PVC panels. It will physically fit the same panel profile in other colors, but it will not colour-match a PROCORE+ Gray Wood wall, so buy the trim that goes with the panels you own.

Can I add trim to a wall that is already up?

Yes. Top trim slides onto the top edge of the panel and you do not have to take the wall down to fit it. You may need to back off the screws in the top row so the trim can seat, then drive them back in.

Which pack size should I buy?

Buy the pack that covers your rounded-up piece count with the fewest leftovers. If you land between two packs, go up rather than down.

Not sure how much you need? Send your wall dimensions to info@garagetoolsstorage.com or text (888) 949-4945 and we will work out the trim list. Prefer to call? Leave a message on (888) 949-4945 and we will reply by email or text.

Related: all slatwall trim · slatwall panels · bundles & kits