Closing the opening
An auto-shutter door powers a panel across the ceiling opening once the platform is down. Beyond appearance, it stops heated or cooled garage air escaping into the attic every time the lift is used, and it removes an open hole above anyone working below.
A fire-rated ceiling panel matters where the garage ceiling is a rated fire separation from living space above — cutting a lift opening interrupts that assembly, and a rated panel restores it. This is a code question worth raising with your local inspector before the ceiling is cut.
Improving the platform
A treadplate platform upgrade swaps the standard deck for treadplate, which stands up better to heavy or sharp-cornered loads. A platform enclosure adds side walls so loose items cannot shift off during travel — worth it if you send up unboxed or irregular loads.
Solving installation problems
A truss leg kit adapts the mounting where the attic truss layout does not offer a clean bearing point for the standard installation. Check your framing before installation day, not during it.
Controls
A spare wireless remote gives you a second controller — typically one kept in the attic and one in the garage — or replaces a lost one. Compatible with wireless (W-series) lifts.
Attic access safety
The Versa Rail Model 60 attic ladder safety rail gives you something solid to hold at the top of a pull-down ladder, which is precisely where attic falls happen. It is a sensible companion purchase even for households that have a lift, since the ladder still gets used.
Frequently Asked Questions
Will the Versa Rail Model 60 fit my attic ladder opening?
It telescopes from 22 1/2" to 30" wide and from 54" to 60" long, which covers most standard attic ladder openings. Measure your opening before ordering.
How is the Versa Rail installed?
Set it to the width and length of your opening, then fasten it to the attic decking with the lag screws provided. No welding or fabrication is needed, and it does not require a Versa Lift.
Does the Aladdin wireless controller work with a lift that is already installed?
Yes. The SL-WLC works with new and existing Aladdin storage lifts and removes the need to install the wired key-switch in the wall. Its antenna lets you run the lift from the garage floor or from the attic.
Can the Aladdin wireless controller be left switched on?
It deactivates after 30 seconds of inactivity, as a safeguard against unwanted use.
